← Back to products

Compliance Information — RF-V1

The following documentation is provided in compliance with ISED RSS-Gen Issue 5 and applicable Canadian regulations.

1. Product Identification

Product NameRF-V1
Model Number(s)RF-V1-900-2LATCH-BATT
RF-V1-900-2LATCH-SOLAR
RF-V1-900-4LATCH-BATT
RF-V1-900-4LATCH-SOLAR
Product DescriptionWireless Irrigation Valve Controller
Manufacturer or Authorized RepresentativeWiseConn IP GmbH
Schochenmühlestrasse 4 6340
Baar, Switzerland
Equipment CategoryCategory I (RSP-100) — integrates only pre-certified radio modules with valid ISED modular approvals
Canadian RepresentativeH2O Integrated Inc.
#255, 203-304 Main Street S.
Airdrie, Alberta. Canada. T4B 3C3
www.h2ointegrated.com
Contact: Amin A. Samra, Business Coordinator
Cell: (825) 488-0080 | amin@h2ointegrated.com

2. Certified Radio Modules Contained

ModuleIC NumberTechnologyFrequency
RAKwireless RAK1172025908-RAK11720LoRa + BLE902–928 MHz / 2402–2480 MHz

3. Applicable Standards

StandardDescriptionCompliance Method
RSS-247 Issue 3DTS, FHS, LE-LANModular approval IC: 25908-RAK11720 + C4PC report CN24RTIB 002
RSS-Gen Issue 5General RequirementsLabeling, manual, documentation
RSS-102 Issue 6RF ExposureExempt per Section 6.6 (EIRP 0.245 W < 2.472 W)
ICES-003 Issue 7Unintentional emissionsTest report CN24RTIB 001 (TÜV Rheinland, 2025-02-10) — PASS

4. Supporting Documentation

Click to download the supporting documents referenced in the SDoC:

5. Product Labeling

Photographs of the product labels as applied to the device:

6. Declaration

This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.